KOR
Reinforcing Bar
Home
Products
Reinforcing Bar
Chemical Element

Reinforcing Bar

Products>Reinforcing Bar>Chemical Element
  • 철근
  • 철근
  • 철근

Reinforcing Bar

HANSCO products are produced with the latest equipment and superior technologies. Even a small product is strictly controlled for the production of products demanded by customers. In the case of high-strength reinforcing bar such as SD400, SD500, and SD600 among our manufactured products, we produce reinforcing bar with superior quality by forming a hardened layer through a rapid cooling process on the surface with water cooling (TEMPCORE) reinforcing bar production method. In addition, we are manufacturing products with various specifications and sizes including special reinforcing bar and seismic proof reinforcing bar according to the rising demand for high-strength seismic proof reinforcing bar. We will continuously respond to the demands of our consumers through constant research & development.

Chemical Element

화학성분에 대한 정보
Symbol Chemical Element (%)
C(1) Si Mn P S Cu N(2) Ceq(1)
SD300 - Below 0.60 - Below 0.050 Below 0.050 - - -
SD400 Below 0.60 Below 0.045 Below 0.045
SD500 Below 0.60 Below 0.040 Below 0.040
SD600 Below 0.60 Below 0.040 Below 0.040 Below 0.67
SD700 Below 0.60 Below 0.040 Below 0.040 Below 0.67
SD400 W Below 0.22 Below 0.60 Below 1.60 Below 0.040 Below 0.040 - Below 0.012 Below 0.50
SD500 W
SD400 S Below 0.29 Below 0.30 Below 1.50 Below 0.040 Below 0.040 Over 0.20 - 0.55
SD500 S Below 0.32 Below 0.30 Below 1.80 Below 0.040 Below 0.040 Over 0.20 Below 0.60
SD600 S Below 0.37 Below 0.30 Below 1.80 Below 0.040 Below 0.040 Over 0.20 Below 0.67
SD700 S Below 0.40 Below 0.60 Below 2.00 Below 0.040 Below 0.040 Over 0.20 Below 0.80

(1) Regarding measurements exceeding D 32 in SD400 W and SD500 W, the carbon content shall be set below 0.25 %, and carbon equivalent below 0.55 %. Regarding measurements exceeding D 35 in SD600 S, carbon content shall be set below 0.40 %, and carbon equivalent below 0.70 %. Note (1) Regarding measurements exceeding D 35 in SD400 W and SD700 W, carbon content shall be set below 0.43 %, and carbon equivalent below 0.83 %.

(2) In case an element combined with nitrogen satisfies more than one of the following standards, it’s ok even if the nitrogen content is high. (Total AL : Over 0.020%, V : over 0.020%, Nb : over 0.015%, Ti : over 0.020%)

(3) When conducting product analysis, follow KS D 0228. The tolerance of product analysis is in KS D 0228 Table-1, and component V among these follows Table-3, and carbon equivalent value is increased as much as the tolerance of carbon element. Nitrogen value is increased by 0.004% in Table 2 of KS D 3504.

TOP